What Is A Tilting Fillet Used For?

The tilt fillet is fixed to the rafters beneath the roof membrane, parallel to the roof tiles. They can also be used to add a slight pitch to a flat roof, allowing water to run off. Or, they can be used to fill the gap between two joists connected at an angle.

What is a tilting fillet construction?

To prevent this, a piece of timber triangular in section is fixed to the rafter and goes beneath the roof membrane, rather than on top like a roofing batten and lifts the tile parallel to the tiles above. This is known as a tilting or tilt fillet.

Do roof tiles rest on fascia board?

Eaves tiles

At the eaves, where there is no tile below, interlocking tiles normally rest on a fascia board or tilting fillet to provide a support for the bottom edge. But the height of the leading edge of this support is critical ¨C and often incorrect.

What is the purpose of felt under roof tiles?

Roofing felt, installed under roof tiles or roof slates, protects the roof space from being exposed to wind and the ingress of rain and snow, should the roof tiles fail, leak, be damaged or be blown off.

What is tile Batten?

Battens are the lengths of wood that are laid in-between the rafters to secure the roofing felt and to accept the tiles or slates when they are fitted. … They are used to locate the roof covering in straight, consistent rows, and provide a strong anchor for the nails or clips used to secure the tiles or slates.

What is a fascia board?

The fascia board is the long wooden board behind the gutters on a house. It connects to the roof rafters, closes off the attic and serves as the mount for gutters. … A damaged fascia can be the starting point for other roof problems and potentially lead to damage to an attic and home.

What are eaves tiles?

These eaves tiles make up the lowest row of tiles at the facia board to provide the double lap for the first row of full tiles. … Eaves tiles are also used for the top row of tiles at the ridge. The top edge of the second row down must be at a level where the ridge tile will cover it.

What are over fascia vents?

Allow air to pass into your roof space between felt and fascia board with Roofing Superstore’s collection of fascia ventilation products. Fascia vents are an unobtrusive way to vent a roof space without having more unsightly vents showing from the tiles.

How long is a length of fascia?

Sizes vary in depth to suit the particular pitch of the roof – most fascias are between 150mm and 225mm deep but our stock range includes both larger and smaller sizes.

Can you put vents in fascia?

Fascia vents are a great way of improving airflow in your roof space via your fascia board, without having to install individual tile vents. … Find a selection of vent sizes according to warm, cold, flat roofs and more.

What are rosemary tiles?

The Rosemary name is synonymous with clay plain tiles, adding distinction and character to pitched roofs for over 175 years. … Produced from the finest clays, Rosemary is offered in a range of weathered, brindled and single colours that create striking and attractive roofs.

What is a soffit?

What Is a Soffit? Your roof by necessity, will often times extend over the walls of your home. This overhang can go by a few names, such as the house eaves or the rafters of your roof. The underside of this overhang, when given a finished appearance, is known as the soffit, which means “something fixed underneath”.

What is roof eave?

The area where a roof extends a small way past the wall of a building is usually referred to as the eaves. … Eaves are formed as the rafters of the roof extend past the side of the building to distribute and support the load of the roof more evenly.

What is the Faccia?

Fascia is a thin casing of connective tissue that surrounds and holds every organ, blood vessel, bone, nerve fiber and muscle in place. The tissue does more than provide internal structure; fascia has nerves that make it almost as sensitive as skin.

Do roofers replace fascia boards?

Most roofers, in that case, are generally trained to spot problems in fascia and gutters as well the training required to take care of them. … Fascia both keeps the gutters secure and seals the interior of the attic to some degree. Every so often in the lifespan of your home, you will see fascia repair or replacement.

What’s the difference between fascia and soffit?

An exterior soffit is located on the span beneath the rafter tails, while the fascia is the exposed horizontal band you see at the end of the rafters. These architectural elements found along the eave area do more than just add visual interest and give a finished look to your home.

Are battens necessary?

You do not have to use a batten roofing system under most building codes. In some cases, it is necessary, but in most cases using batten on your roof is a choice to gain the benefits of using this system. There are primarily two options for roofing, a direct to deck system or a roof batten system.

Is tile batten treated?

Treatment – Roofing battens should be preservative treated to Use Class 2 in accordance with BS 8417. Different manufacturers use their own types of preservative treatment and may offer different guarantees as a result.

What are Type A battens?

These Green Treated Battens are Type A and are ideal for a wide range of construction applications. Green wood is freshly cut and will have a high moisture content compared to seasoned timber. The green treated battens are flexible and soft making them a great choice for lathe and chisel work.

How much do you overlap rosemary tiles?

Below 90 degrees, Rosemary tiles should be laid at 60 tiles/m² and at 90 degrees (where the tiles are used on a vertical section of the roof) they can be laid at 52 tiles/m². This is due to the increased overlap that you need for lower pitched roof to retain the excellent weather protection of the Rosemary Tiles.

What is the batten gauge for rosemary tiles?

Batten size : 38mm x 25mm – rafter centres up to 600mm.

What is the size of a rosemary roof tile?

Size: 265 x 165mm (10.5″ x 6.5″) Minimum Pitch: 35°

Related Q&A: